AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

RE: Interfacing THS1206

Hi, I've read your post up. I'm trying to do the same thing. If possible, can you give me some sample code for that. Your help is greatly appreciated. Regards, Nash > > > ...

mcbsp in gpio mode   [2 Articles]

dear friends I am configuring TMS320C6211 in GPIO mode for PC communication. In this context I am in need of few MACROS, kindly tell me in which laibrary these MACROS ...

Re: SDRAM   [3 Articles]

Arun- > Processor: 6211, Big Endian > Emulator: XDS510PP Plus > Customized Target Board, having SDRAM as the memory. > > I am facing the problem with SDRAM communicati...

Re: GEL file of .CMD file?

Arunav Kumar- > Hi Sir,I am working over the processor: - TMS320C6211 I have a customized board, on > which I am able to write in to the Internal memory (L2RAM), that belongs t...

No trace of Chip Select/Data Bit in out put, Please Help   [4 Articles]

Hi to all, I have a problem described below: - I have a customized DSP Target board, that consists TMS320C6211 DSK processor, No memory chip (FlashPROM, SDRAM etc.) avai...

Problem with TMS320C6711 DSK codec read/write test   [3 Articles]

External codec tone generation test is ok, memory test is also ok. But when i try to use microphone to test codec read/write - there is no voice heard. Microphone is ok. I trie...

POD_ERR_RESET message when loading CCS with DSP connected   [2 Articles]

Hi I've been using a TMS320C6211 DSK starter kit, and have communicatin with it using the parallel port, which was correctly configured. After accidentally connecting ...

DSK problem   [3 Articles]

Hi, I have a TMS320C6211 DSK [processor: TMX320C6211] and cannot get my laptop to communicate with it. I have gone through previous emails in this group on similar to...

Re: Initial Design   [8 Articles]

Hello Brian,   I hope that I don't run off of the 'deep end' with my ramblings, but I am always glad to share.  Of course there is no single answer to your ques...

6211, McBsp Interrupt problem

hi DSP pals i have problem with McBsp interrupt. we are using TMS320C6211 from TI ,we are using McBsp channel 0 , which recieves ST bus samples, we are usin...

McBsp Problem   [2 Articles]

Hello pals I am using Tms320C6211 DSP & CCS ver 2. I am configuring the McBsp port using the MCBSP_configArgs . I find this strange observation. The SPCR ,RCR,...

Booting from ROM   [2 Articles]

Hello pals    Can any one suggest as how to go about writing a BOOT code from ROM in case of TMS320C6211 DSP. C6211 copies 1k from CE1 to on chip mem. bye ...

ROM Booting for C6211 DSP

Hello pals I using Tms320C6211 DSP ...a customized board for a telephony application. I have a 128KX 8 EPROM connected at CE1 space. Tms320C6211 is a single map ...

codec-edma query ??

Hello, I am working with TMS320C6211 Codec_edma program. I am trying to implement a DWMT(discrete wavelet multitone modulation) system on the audio data that i ob...

Codec_Edma

Hello, I am working with TMS320C6211 Codec_edma program. I am trying to implement a DWMT(discrete wavelet multitone modulation) system on the audio data that i ob...

Re: microphone out put   [3 Articles]

thanks for reply we are using TMS320C6211 DSP based customized board for communication purpose. the codec connected is TMC38C17. we could able to record and play ...

multiple input

i am using this starter kit to develop an active noise control real time simulation program. the tms320c6211 dsk starter kit has only one input and one output port,...

ROM booting

We are using Tms320C6211 DSP under 8 bit ROM boot configuration CE1 space,ie HD[3]-HD[4] being {1,0}. Iam testing the CE1, Data Bus and Address bus of ROM I ha...

booting from eprom

Hello DSP Pals !! I am Mr R.J.Nayaka from CTI controller Group,ITILtd, SW R&D ITILtd, Bangalore. We have the following configuration DSP : TMS320C6211 E...

Re: PAL on the C6711 DSK

Stanley- > I'm facing a situation that I wanna to sent a parallel port interface control > signal to my daughterboard by using the programmable array logic (Modu...

32-bit register, 16-bit DAC?

Hello, I am using a TMS320C6211 DSK and obviously a beginner. I would like to send some samples out the codec representing a time domain waveform. My problem...

DSK C6x11 board schematic   [2 Articles]

Peter- > I didn't receive any schematics with the board. I have > looked everywhere on ti's website. The only datasheet > on the ad535 says it is programmable ...

configuring the sampling rate of tlc320ad535?   [3 Articles]

Hello, I am using the TMS320C6211 DSP starter kit which has an on board codec (the tlc320ad535). The codec's max sampling rate is 11.025khz, but i would like to c...

Endian problem   [2 Articles]

freinds we are using TMS320C6211 dsp custom board, and we are feeding programs through JTAG thru XDAS510PP,while working with CCS its giving some time Little End...

PAL contents   [2 Articles]

hi all, I would like to know where can I get the PAL contents of TMS320C6211 DSK ??? Looking Forward....... Simha ...

Interfacing THS1206   [2 Articles]

Hi all. I am looging for information or documentation about how to interface the TMS320C6211 board (parallel port) with the THS1206(ADC) Carlos A. Gutierrez...

problems with auido example of the 62211

Hi: I am beggining to work with the TMS320C6211. I am triyng to run the audio example located in ....ti\c6000\examples\bios\....., but this is not working. ...

Re: TMS320C6211 vs. TMX320C6211

It is true that the TMX parts are not completely qualified, whereas the TMS parts are completely qualified and supported. However, the chip revision is independant ...

RE: (unknown)

The DSK's parallel port can interface to either Code Composer Studio for emulation or to the HPI via a Win32 DLL. The Win32 DLL contains a dozen or so functions tha...

(No Subject)   [2 Articles]

Hello, I'm trying to interface a TMS320C6211 DSK-Board in order to transfer data from the DSK-Memory to a Linux PC. I cant find any information in the manu...

Speed and the need for   [3 Articles]

Hi, we're considering a C6711 DSK. The Ti Site ( http://focus.ti.com/docs/tool/toolfolder.jhtml? PartNumber=TMDS320006711) states, "Operating at 150 MH...

TMS320C6211 Rev1.0, McBSP

Hi Is there anybody who has already used the new 32bit-reversal feature of the McBSP in the TMS320C6211? It seems that RWDREVRS (bit 4 in the receive control r...