Hi all,
I need to find all real $u$'s, such that
$$\sum_{i=1}^{n}{\left(\frac{w_{i}}{u-e_{i}}\right)^{2}}=1$$
where $$\sum_{i=1}^{n}{w_{i}^2}=1$$ and w_{i}'s and e_{i}'s are given.
My ques...
Instead of just taking the convolution of a signal with the reference
or kernel once and then taking the square root in the frequency
domain, why not match filter with the reference again and again ...
Hi all,
just out of curiosity, I was digging into the RS codes,
mainly for RAID-6 purposes.
So, I was wondering about the possibility of increasing
the parity of such RAIDs.
Looking around ...
What has been and is being called "matched filtering" might better be
called "a few steps short of complete match filtering" [which has the
often desirable effect of _adding_ in some low pass filter...
To demodulate AM, I use the formula am = sqrt(I*I + Q*Q)
I am mixing an AM IF signal to baseband, i.e. carrier plus 2 sidebands. My
test signal is modulated at 800Hz.
When I look at the demodula...
i will try hard to abide by my own advice. i hope we can all agree to
this effort.
--
r b-j rbj@audioimagination.com
"Imagination is more important than knowledge."
...
Hey,
I just watched a demo of this amp profiler...I guess it's a kind of
system identification algorithm running under the hood? Any guesses as
to what type of algorithm is used to identify the a...
2260
W Gary Sokolich
801 Kings Road
Newport Beach, CA 92663-5715
(949) 650-5379
Local PD
949-644-3681
Residence:
5309 Victoria Ave., Los Angeles, CA, 90043
http://web.archive.org/web...
Folks,
I have few basic questions on related to compression used in JPEG.
1. Is the DCT applied over Y, CB and CR separately?
2. Is there a specific reason why DCT is chosen over DFT?
3. Ca...