Sign in
Search adsp
Subscribe to adsp
Ads
Discussion Groups
See Also
Discussion Groups | Analog Devices DSPs
Technical discussions related to Analog Devices DSPs (including Blackfin, TigerSHARC, SHARC and ADSP-21xx DSPs).
Image processing methods testing using MATLAB [3 Articles]
"koe...@rocketmail.com" - Oct 21 2010
Is MATLAB the only good program available for image processing?
ARe there any other programs that are just as good but also possibly cheaper?
Thanks.
... 
BF518f - Reading and writing to the SPI FLASH and to the on-chip FLASH [2 Articles]
Chagai Ensenberg - Oct 21 2010
Hi,
My application boots from the external flash. then is runs for a while and
aquires and generates some data. Then it goes back to sleep for a while.
When it wakes up again ... How to read data from FIFO without address bus [6 Articles]
lake...@gmail.com - Oct 18 2010
Hi there:
I have a design with ADSP21369 reading data from FIFO connected via EMIF. The FIFO I am using comes without address bus. The full flag of FIFO is connected to the IRQ of... PWM code for VDSP++ [2 Articles]
ash3...@rediffmail.com - Oct 14 2010
I am engeged with the hardware coding of Blackfin BF537 in embedded C using VisualDSP++ compiler/assembler. The first motive of my project is to write the processor specific C code... Seeking advices for starting a project. [2 Articles]
msha...@gmail.com - Oct 13 2010
We are starting a new project for developing an Electrocardiograph. We have an Acquisition module which gives 12 channel information from 12 leads. We are planning to use ADSP BF 5... waking the BF from sleep/deep-sleep with an external trigger from CODEC [2 Articles]
chagai_e - Oct 11 2010
Hi All,
I'm using the BF 518 EZ-Board. I'm in the proccess of designing my own custom board and need advice:
My application is a real time low power application in which the ... Boot flash image for ADSP-21065 EZ-LAB [8 Articles]
Alexander Perkalsky - Oct 10 2010
Dear friends,
I have some problems while experimenting with ADSP-21065 EZ-LAB kit. I have an old version, with RS-232 comms to PC and bundled Visual DSP 4 trial. I realize that ... bf-518 power saving modes RTC [3 Articles]
Chagai Ensenberg - Sep 28 2010
Hi,
I'm using the bf 518 evaluation board.
my application needs to perform some kind of a test once an hour. in the
rest of the time It should sleep / hybernate in order to sa... Blackfin USB driver for WinCE
msha...@gmail.com - Sep 1 2010
Hello Friends
I am a newbie to this embedded world.I just joined a small startup company in my place as a trainee directly after i completed my degree in Electronics Engineer... Alternatives to ADZS-HPUSB-ICE? [4 Articles]
"Wachob, Chip" - Sep 1 2010
Hello,
I'm wondering if anyone out there has knowledge of a
USB-based ICE for the 21469 family that is less costly
than the ADZS-HPUSB-ICE. I'm not certain if the slower
...