AD1819 | AD7332 | ADSP-2106 | ADSP-21060 | ADSP-21065L | ADSP-2116 | ADSP-21160M | ADSP-2181 | ADSP-218x | ADSP-219 | ADSP-2199 | ADSP219 | BF531 | BF532 | BF533 | BF535 | Blackfin | FFT | JTAG | LDF | SDRAM | SHARC | SPORT | UART | VDSP++ | VisualDSP

I am using a ADSP 2181 KST133 Rev 0.2 and I am trying to boot from an external EPROM (MMAP=0,BMODE=0). The DSP only activates the address bus and the BMS signal at reset. The BMS signal stays high. Another effect is that at CLKOUT no signal is at reset. I think that the PLL doesn't lock altought the reset time is longer than 2000 CLKIN cycles. The DSP only makes garbage also after a second reset. Are these problems effects of the low Revision number or is there anything else I have to consider? Regards Rainer Rupp

______________________________
Start your Android Ice Cream Sandwich development on TI's AM35x Sitara ARM Cortex-A8 processor today.



(You need to be a member of adsp -- send a blank email to adsp-subscribe@yahoogroups.com )