Please refer to the chapter-10 of ADSP-21065L User Manual.
The minimum size supported for SDRAM is 16 MBytes.
If you use any size less than 16 MBytes (as you seem to be currently asking),
you will not be able to use some of the address ranges of SDRAM - because these address ranges
will be aliased to some other address ranges.
For example with 8MByte SDRAM (as you are asking), 
(1) remaining 8 MByte will be unusable. 
(2) The unusable memory section will not be contiguous (there will be smaller aliased blocks).
for exact address ranges of aliased blocks, you will have to do some calculations based on
address space specified in the chapter-10.
(3) You can however manage with this SDRAM without any hardware changes. All you need to do is
to configure LDF file not to use any of the aliased address blocks.
(4) With new configuration you may be in trouble, if your application requires contiguous
external memory of 8 MBytes.

Regards,
Kunal Singh
www.singhkunal.com
>  
>
>    
>  Hello, guys.  
>  
>Do you know if 2M x 32 SDRAM parts like Micron's MT48LC2M32B2TG or  
>ISSI's IS42S32200 would work smoothly and flawlessly with the 21065L  
>clocked at 60MHz? When I say "work smoothly and flawlessly" I mean  
>without special hardware or software tricks, like the on-board SDRAM  
>on the ADDS-21065L-EZLITE does.  
>  
>Any pointers to this issue, and references to other suitable SDRAM  
>parts are very welcome.  
>  
>------------------------------  
>Jaime Andr�s Aranguren Cardona  
>SanJaaC Electronics  
>  
>  
>  
>      	    
>  
>