hello friends,

i am new bee for programming using blackfin or any microcontroller chip. i am using blackfin
adsp bf537 for embedded and signal processing purpose. application is real time gas analyzer
and making first prototype of this instrument. from hardware of this instrument, i have to
transfer approximately 1 volt real time signal( varied continuously, looks like a spike) on
ADSP BF537.i must see the same analog signal on computer using BF537 as embedded purpose.but, i
do not have programming skills. should i have to make program using C langauge or on labview
8.1 or both? can you explain me the steps of programming for this type of problem.whatever
signal getting on oscilloscope, i should represent it on computer using ADSP BF537 evaluation
kit. i have no idea of steps of programming for this type of problem. please help me show the
right direction. so that, i can learn in right direction and can solve this problem. thank
you.
   
  Regards,
  Jal

---------------------------------
 Download prohibited? No problem. CHAT from any browser, without download.

hello Javier Herrero,
   
  thanks for your reply. well, if you show me path of programming as per your understanding,
then i would be grateful. we dont have enough finance to do this by help of consultant. if you
show me basic path to solve this type of problem, then i can collect some knowledge in
particular direction. because on its website, they keep lots of information, i dont know which
information will be more informative for me. i hope that you can understand me and will share
your knowledge! thanks..
   
  regards,
  Jal

Javier <j...@nebulosa.org> wrote:
  Dear Jal,

As you can understand, it is quite difficult to explain you all the 
intrinsics of the data acquisition you need, more without previous 
knowledge of your hardware platform - the only information you give is 
that you are using a BF537 - in few words. Have you considered to 
contract a consultant on this field? We are very knowledgeable in 
digital signal processing algorithms and implantation, both software and 
hardware, and also have experience in the development of gas analyzers, 
mainly for pollution measurement applications.

Best regards,

Javier Herrero

jalpa vasani escribió:
> hello friends,
>
> i am new bee for programming using blackfin or any microcontroller 
> chip. i am using blackfin adsp bf537 for embedded and signal 
> processing purpose. application is real time gas analyzer and making 
> first prototype of this instrument. from hardware of this instrument, 
> i have to transfer approximately 1 volt real time signal( varied 
> continuously, looks like a spike) on ADSP BF537.i must see the same 
> analog signal on computer using BF537 as embedded purpose.but, i do 
> not have programming skills. should i have to make program using C 
> langauge or on labview 8.1 or both? can you explain me the steps of 
> programming for this type of problem.whatever signal getting on 
> oscilloscope, i should represent it on computer using ADSP BF537 
> evaluation kit. i have no idea of steps of programming for this type 
> of problem. please help me show the right direction. so that, i can 
> learn in right direction and can solve this problem. thank you.
> 
> Regards,
> Jal
>
> ------------------------------------------------------------------------
> Download prohibited? No problem. CHAT 
> 
> from any browser, without download.
>

---------------------------------
 Download prohibited? No problem. CHAT from any browser, without download.