Sign in
Search c28x
Subscribe to c28x
Discussion Groups
Discussion Groups | TMS320C28x
Technical discussions about the TI C28x DSPs (including the C2810, C2811, C2812, F2801, F2806, F2808, F2810,, F2811, F2812, R2811 and R2812).
Acceleration/Deceleration in PWM [2 Articles]
msr_...@yahoo.co.in - Sep 28 2007
Hi all;
In my project i am using TMS320F2812 controller to control the Servo motor using inbuilt PWM.In that to start and stop of the servo motor requires Acceleration in start ... 
Regarding INTERRUPTS
msr_...@yahoo.co.in - Sep 24 2007
Hi all...........
In my project i am using TMS320F2812 Controller.In that i am not using some of the all the digital peripheral I/O s(CAN,Mc BSP,PWM,QEP).
These pins are config... Regarding SPI [4 Articles]
msr_...@yahoo.co.in - Sep 24 2007
Hi EVERYBODY
I am using TMS320F2812 Controller.In that i have to receive 8 bit data from one microcontroller.I configured SPICCR as 8 bit Character length,in scope i am getting ... about 2808 interface with LCD
saur...@yahoo.com - Sep 21 2007
i have writen small LCD16x2 interface code for 2808. The code runs perfect with the RAM. but when i use it with the Flash after the reset the display is uncertain sometimes it work... something about program boot and bootloader..
rub....@gmail.com - Sep 21 2007
I am a beginner on the TMS320F2812 .I am very puzzled on program boot, I mean, after emulator connected , and the program well compiled , linked and load, the program will run from... Problem: Composer could not locate Flash28_delay.asm
Viktar Palstsiuk - Sep 18 2007
Hello
I'm having a problem with flashing TMS320F2811 using CCS (v3.1)
On-Chip Flash Programmer plugin (v1.12.5).
After I stop 'frequency test', I get a message "Code Compose... Generation of Three-phase Sine-wave PWM patterns
ber2...@wp.pl - Sep 17 2007
Hello,
I am beginner in programming controlers from TI. I am trying to make simple open loop control of induction motor using sinusoidal modulation PWM. I am using TMS320F2812 e... Control of PWM
msr_...@yahoo.co.in - Sep 14 2007
Hi I am using TMS320F2812 DSP controller.In that i am generating pwm wave form by using compare and period registers.Its all ok,,Once its started generation of pwm,,i want to stop ... Newbie Doubt on TMS320F2812's McBSP
arm_techie arm_user - Sep 13 2007
Hi,
I am using TI's TMS320F2812 DSP controller.
When I tried McBSP in Digital Loopback mode without compression, it is
working fine.
But the problem arises when I am trying... PWM Generation
msr_...@yahoo.co.in - Sep 12 2007
Hi to all;
In my project I am using TMS320F2812 DSP controller,in that i have to generate PWM waveform to run the seromotor.To control the servomotor I have to control pwm ou...