Technical discussions about the TI C28x DSPs (including the C2810, C2811, C2812, F2801, F2806, F2808, F2810,, F2811, F2812, R2811 and R2812).
Post a new Thread
Khisrow Seadeqi - Apr 23 2009
Hello Every one
I am trying to read the ADC result from an AC load but the results keeping floating, however when I try to read directly from the DC supply I get constact result. ... 
Akhilesh Tripathi - Apr 23 2009
Dear friends,
I am using eZdspf2812 board for some time for on line generation of PWM pul=
ses which will be used in IGBT bridge. But now once I power-ON the board an=
d start C... 
naay...@gmail.com - Apr 21 2009
Hi all,
How can i make use of graph window in codecomposer studio to display the ADC value for 20kHZ input signal? i am using buffer size of 25. I couldn't display the inputs pr... 
bhaba das - Apr 16 2009
Hi all;
can anyone give me some idea how to use the embedded target for C2000 in
simulink to generate a model & subsequent code for a 12 pulse ac/dc power
converter to be cont... 
s.el...@yahoo.fr - Apr 15 2009
hi,i'm programming with TMS320F2808 via simulink.i need to change my parameters during simulation without halting and rebuilding program and i need to get results in the same time.... 
tms320f28234 - Apr 4 2009
I am working on a project porting a medium sized legacy project from a
LF2407A to a 28335. In the legacy code, the software relies on the .bss
section being initialized to zer... 
gast...@yahoo.com - Apr 4 2009
hi,
i try to make a connection between dsp c28335 and msp430, i use simulink to do the i2c link, but the dsp is not responding to the msp430, i use the oscilloscope to see the dat... 
Song Lin - Mar 25 2009
I have a few questions about ADC time.
1. In the ADC reference guide (SPRU060D), it shows on page 1-7 that, in simultaneous mode, 4 ADC clock periods are required before the res... 
namrita_shenoy - Feb 19 2009
Hi,
I have integrated sprc081 with my project and was able to get some
results. The fft.mag gave 0 for all 64 points (I used 128 point real
FFT). The document mentions that ... 
kvai...@gmail.com - Feb 19 2009
Hi, I am trying to run an incremental encoder based motor from F2812 using PMSM3_4.(reference code). I am able to run the motor upto build level 3. But when I am trying to match th... 
previous |
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
next