Hello, Im pretty new to DSP.  I am currently using the spectrum digital eZdsp board with
the 2812.  I would like to use 2 channels to run an A/D and then output these to the PWMs at
10Khz.  Ive gone through the examples (Ev_PWM and ADC_soc) and got them to work but I cant
figure out how to take my ADC results and run them through the PWMs.  Any suggestions?
-Colin

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________