Sign in

username:

password:



Not a member?

Search c28x



Search tips

Subscribe to c28x



Ads

Discussion Groups

Discussion Groups | TMS320C28x | no power to target device?

Technical discussions about the TI C28x DSPs (including the C2810, C2811, C2812, F2801, F2806, F2808, F2810,, F2811, F2812, R2811 and R2812).

  

Post a new Thread

no power to target device? - nyshishirny - Jun 7 11:14:31 2007



Dear Members,

I am using XDS510PP_Plus JTAG emulator to program TMS320F2812 DSP.
I used SDconfig v3.1 software to check the connectivity.

The software SDconfig detected the emulator properly.
But, when I checked the "Reset Emulator" button, it said 
           "Error : No power to target"

All the connections are proper and voltage at the pin PD (Presence
Detect) of the emulator was 3.25 V.
I am not able to figure out what the problem is. Is the DSP spoilt?
Please help.

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________


(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )

Re: no power to target device? - Vikram Rajput - Jun 11 12:36:25 2007

Looks like your DSP is damaged.
Try to connect another board, if you have any.

On 6/7/07, nyshishirny <s...@zapak.com> wrote:
>
>   Dear Members,
>
> I am using XDS510PP_Plus JTAG emulator to program TMS320F2812 DSP.
> I used SDconfig v3.1 software to check the connectivity.
>
> The software SDconfig detected the emulator properly.
> But, when I checked the "Reset Emulator" button, it said
> "Error : No power to target"
>
> All the connections are proper and voltage at the pin PD (Presence
> Detect) of the emulator was 3.25 V.
> I am not able to figure out what the problem is. Is the DSP spoilt?
> Please help.
>


(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )