Has anyone been able to make the analysis unit work when trying to 
break on data writes to a memory location.

ie. Set a breakpoint when a memory location x = 5.

The unit is suppposed to be able to do this, but I have been unable to
make it work. Tech help at TI has not been able to resolve this for
me yet.

Andy

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________

 

with CodeComposerStudio v3.3, open Emulator Analysis Panel, right clic,=20
AU1 Setup , Enabled AU1, Bus Address monitor -> Add your address to stop.
You can also Chain AU1 & AU2 for example to stop when writing a specific=20
data at a specific location. For this ->  AU1 Setup -> Chain breakpoint=20
(enabled AU2)

hope this help, it works few month ago for us to stop when writing at a=20
particular address.

Envoy=E9 par :    c...@yahoogroups.com
Pour :  c...@yahoogroups.com
cc :=20=20=20=20=20

Objet : [c28x] F28xxx Analysis Unit

Has anyone been able to make the analysis unit work when trying to=20
break on data writes to a memory location.

ie. Set a breakpoint when a memory location x =3D 5.

The unit is suppposed to be able to do this, but I have been unable to
make it work. Tech help at TI has not been able to resolve this for
me yet.

Andy

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Tr=
anscoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm64=
67

You can post a message or access and search the archives of this group on D=
SPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________

=20