Technical discussions about the TI C28x DSPs (including the C2810, C2811, C2812, F2801, F2806, F2808, F2810,, F2811, F2812, R2811 and R2812).
we have kept the reset pin normally floating. and after power up ,we are making it HiGH to start the bootloader. Does the controller reset by pulling the Reset Pin High or Low? ------------------------------------ Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467 You can post a message or access and search the archives of this group on DSPRelated.com: http://www.dsprelated.com/groups/c28x/1.php _____________________________________
hi
F2812 donot need any power sequence for power-up or power-down but you it must be see high
edge of reset signal after full power-up.(SPRC174O-Section 6.9)
Amin
n...@gmail.com wrote:
we have kept the reset pin normally floating. and after power up ,we are making it
HiGH to start the bootloader.
Does the controller reset by pulling the Reset Pin High or Low?
------------------------------------
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467
You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php
_____________________________________
Don't let this pin float. Chao --- AminRezaie <a...@yahoo.com>дµÀ: > hi > F2812 donot need any power sequence for power-up > or power-down but you it must be see high edge of > reset signal after full power-up.(SPRC174O-Section > 6.9) > Amin > > n...@gmail.com wrote: > we have kept the reset pin normally > floating. and after power up ,we are making it HiGH > to start the bootloader. > > Does the controller reset by pulling the Reset Pin > High or Low? > > ------------------------------------ Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467 You can post a message or access and search the archives of this group on DSPRelated.com: http://www.dsprelated.com/groups/c28x/1.php _____________________________________
What is SPRC174O document....i am not able to find it on TI site. we have kept the reset pin normally floating. and after power up ,we are making it HiGH to start the bootloader. > >Does the controller reset by pulling the Reset Pin High or Low? > ------------------------------------ Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467 You can post a message or access and search the archives of this group on DSPRelated.com: http://www.dsprelated.com/groups/c28x/1.php _____________________________________
IS this to be kept high normally and then switch it to low on reset? we have kept the reset pin normally floating. and after power up ,we are making it HiGH to start the bootloader. > >Does the controller reset by pulling the Reset Pin High or Low? > ------------------------------------ Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467 You can post a message or access and search the archives of this group on DSPRelated.com: http://www.dsprelated.com/groups/c28x/1.php _____________________________________