I have pull-up for GPIOF4. After powering up, the
program goes nowhere, and the board don't respond as
expected. Then I connect to the board through JTAG
link, and reset the cpu, then just run the cpu(don't
load any program because the program have been
programmed into flash), everything is ok. It seems the
flash boot mode is selected correctly. But without
jtag, it does't work. why?

Chao

------------------------------------

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________

hi,
have you included the CodeStartBranch.asm in your proyect?. I had a similar problem but it was
just that i forgot to include it.
i hope it helps
Ana 

I have pull-up for GPIOF4. After powering up, the
>program goes nowhere, and the board don't respond as
>expected. Then I connect to the board through JTAG
>link, and reset the cpu, then just run the cpu(don't
>load any program because the program have been
>programmed into flash), everything is ok. It seems the
>flash boot mode is selected correctly. But without
>jtag, it does't work. why?
>
>Chao
>

------------------------------------

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________