Hi,

I am running my program in RAM of F2812. I gave COMCONA as 0xA660 and COMCONB as 0xA660. But I
didn't get any output, while I saw the value of this register in watch window it shows that
0x0100 for both COMCONA and B. I think somehow PDPINTx is set to 1, that's why it show as
0x0100. If I power off and run my program again, it shows the similar value for the register.
So I couldn't see the PWMs.
How can I reset this? Is there any other way to handle the situation?

Thanks very much

Regards
Bala
------------------------------------

OMAP35x EVM jump-starts low-power apps
------------------------------------
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to start building
applications based on the OMAP35x architecture:http://www.DSPRelated.com/omap35x
You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________