Dear everyone£º

    My emulator and target board run properly before today, however, when I
open my develop environment and debug my program again it appeared the error
information as follow: 

1)         Power Failure on Target CPU: Error 0x00001020/-1145 Error during:
Execution, Target, 

2)          Unrecoverable emulation error  Sequence ID: 16 Error Code: -1145
Error Class: 0x00001020
Failed to remove the debug state from the target before disconnecting.
There may still be breakpoint opcodes embedded in program memory.  It is
recommended that you reset the emulator before you connect and reload your
program before you continue debugging.

Please give me some suggestion or correct answer

Thank you very much

----------------------------------------------------

Best regards

George

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )