hi all,

i have reviewed the the datasheet of the 2812 DSP, regarding the PLL
configuration, and SPI,

the question is, i have 30Mhz crystal, and PLL configured to make 150Mhz, now i
want to use the SPI, in Slave mode, the equation is = LSPCLK/(SPIBRR+1) 
,,,,,now i want to know the    LSPCLK   what is this value, its not cleared at
all in the datasheet, how can i caculate it ,,,,,, specially with the PLL being
150Mhz,,,,

thanks in advance

_____________________________________

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )

Hey:

I recommend you to download and read the clocking section of spru078.It would be
helpful.

_____________________________________

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )

Dear All,

thanks alot, i downloaded and i have read it too, what is confusing me, is
there is four clocks,
1- the source clock, which in my case 30Mhz
2-PLL clock after multiplying it in my case its 150Mhz
3- High Speed clock
4- Low clock for the SPI communication

im little confused, if i configure the LSPCLK ,,,,what will be the normal
clock of the program, i mean it will be still as 150Mhz, from the PLL, or it
will be affected,,,,,,,or the LSPCLK  will only affect on the SPI,
communication,,,

another thing, if i wanted to connect it through UART, is it okay to connect
the DSP directly -without rs232- to another controller.......i mean the Tx
and Rx just connected together,,,,,,or it will be crossed,
thanks again, Greeting, have a wonderful Night/Day
hasan

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )