I've got 3 little problems with simulink and code composer studio:
the first one is how to include the library paths for custom_mw, the only way i have been able
to make it work was to modify build options of ccs, but i would like to do it just from
simulink.
the second one is a warning i get loading the program, it says it falls in a non writable
memory region, this happens even with simulink demos, so i think it doesn't depend on the
simulink scheme.
the third and most important is that when i use the block c28xadc, even the simulink demo
"ADC control of pwm Duty Cycle" the program gives a "s/h breakpoint", it
stops on "interrupt void ILLEGAL_ISR(void)" contained in DefaultIsr.c; it is written
that the following two lines are for debug only and i should remove them after inserting ISR
code. if i remove them the program doesn't halt on, but it doesn't work as it should.

i am using matlab 7.1 and code composer stodio 3.1.19
Thank You Very very much

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________