Sign in

Search c28x

Subscribe to c28x

Discussion Groups

Discussion Groups | TMS320C28x | Running code without JTAG-Emulator?

Technical discussions about the TI C28x DSPs (including the C2810, C2811, C2812, F2801, F2806, F2808, F2810,, F2811, F2812, R2811 and R2812).

Post a new Thread

Running code without JTAG-Emulator? - "selig.peter" - Nov 6 13:20:06 2006

Hi,

I'm using CCS 3.1 and a Signum JTAGJet C2000 for a F2801.
Code download into flash or ram, debugging, etc. works fine.

If I load the code into flash using the Flash Programmer Utility 
included in CCS I can debug it via JTAG.
But the DSP won't execute any program if I remove the JTAG header and 
pull the reset line.

Are there any options I have to set for stand-alone operation?
The three boot mode select pins are pulled high (= boot from flash).

What's wrong?

Thanks,
Peter

You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________

(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )

Re: Running code without JTAG-Emulator? - b.du...@hart.co.in - May 16 10:06:38 2007

Hi Peter,

I am facing  same prob.

Did you found any Solution?

>Hi,
>
>I'm using CCS 3.1 and a Signum JTAGJet C2000 for a F2801.
>Code download into flash or ram, debugging, etc. works fine.
>
>If I load the code into flash using the Flash Programmer Utility 
>included in CCS I can debug it via JTAG.
>But the DSP won't execute any program if I remove the JTAG header and 
>pull the reset line.
>
>Are there any options I have to set for stand-alone operation?
>The three boot mode select pins are pulled high (= boot from flash).
>
>What's wrong?
>
>Thanks,
>Peter
>
You can post a message or access and search the archives of this group on DSPRelated.com:
http://www.dsprelated.com/groups/c28x/1.php

_____________________________________

(You need to be a member of c28x -- send a blank email to c28x-subscribe@yahoogroups.com )