Sign in
Search c3x
Subscribe to c3x
c3x by Keywords
Sponsor
Discussion Groups
See Also
Discussion Groups | TMS320C3x
Technical discussions about the TI C3x DSPs (including the C31, C32 and C33 DSPs).
Efficient memory usage [2 Articles]
tun875 - Nov 9 2006
Hi everyone,
I am programming for the VC33 and want to optimize the way memory is
currently being used for a large amount of C code. I have a couple
of questions on how to ... 
University DSK 8 IO pins [5 Articles]
cont...@juno.com - Nov 6 2006
Where are the 8 digital IO pins mentioned on the University TMS320VC33 DSP =
Starter Kit web sites? What is the name of those pins on the board?
http://focus.ti.com/general/do... Re: Analog input for C33 University DSK
Kaustubha Reddy - Oct 31 2006
Thanks for the help, Mike. I'll try that here.
"c...@juno.com" wrote:
Hi Kaustubha Reddy,
I used siggen3 in the DSK3\DSK3\C_APPS folder.
change
if(IOF&0x8)
{
f = x... 64 bit Math functions for C31 [2 Articles]
mm_k...@yahoo.com - Oct 30 2006
hello all,
I need 64bit Math functions for TMS320C31. If any can help me, Please
informe me.
thanks
kashi
... Problem with C31 , Please help me [3 Articles]
mm_k...@yahoo.com - Oct 4 2006
Hello all,
I design an evaluation board with TMS320C31 and i have a problem,
I write a program in C and compile it with CC4.1, when i use this line :
retval += *ptr & 0x00000f... Digital out from TMS320c31
mark...@ee.pdn.ac.lk - Aug 29 2006
Dear All,
I want to get digital out(before D/A) from TMS320c31 DSK. Any additionl circuit needed?.What are the ports?.
Thanks
Regds
Mark
... Control Code Request
pang...@ece.ucsb.edu - Aug 22 2006
Hello All,
I am research student looking for control code for embedded
processors/microcontrollers that use PID or LQR closed-loop feedback
control. My group and I want to per... Re: [Fwd: DSK3DW error message when execute freerun]
Keith Larson - Aug 18 2006
Hello Yosuke
I did not keep the correspondance with Leonard so must work from memory.
If I recall this properly the problem was with trying to set breakpoints
within both a... Re: [Fwd: need assembly code for sinx using look up table]
Keith Larson - Aug 18 2006
Hello Nupur
The basic principle you need to know is that you can treat address
labels as simple numbers. This means you can add, subtract and (in
theory) even multiply them... need assembly code for sinx using look up table
mitt...@rediffmail.com - Aug 9 2006
hello everyone,
i just joined this group.
i want to know how to create a look up table in assembly?
by using this look up table generate values of si...