Boot | C31 | TMS320VC33 | VC33

Hi,

I am using TMS320VC33 in MCBL mode.But till now we haven't done any boot loader
programs, as we are in the initial stages of programming.We are simply writing
some code for adc, dac etc for testing purposes.Initially it was fine.

But nowadays we find some kind of degradation in the performance of DSP in the
sense that,after we run the program twice or thrice the dsp stops
responding.hardware or software reset doesn't have any effect.the XDS510pp
emulator shows it is still connected but there is no effect.sometimes an error
pops up which says that trouble stopping the DSP.Keeping the dsp idle for some
time also creates the same problem.We have to switch off the power of the board,
take out the pp connector then pin it again, give the power again then only the
code composer will start.

Is this something that I should be bothered about or will the dsp function
smoothly after we have a proper boot loading program.

Thanking you
Asha

______________________________
StarterWare provides C-based no-OS platform support for the C6000 DSP devices.
Click here for details.



(You need to be a member of c3x -- send a blank email to c3x-subscribe@yahoogroups.com )