hi,
Where can I find a free vocoder near or less than 11kbps for C54x DSPs?
Regards
------------------------------------
OMAP35x EVM jump-starts low-power apps
-----------...
Hi,
1-As I know in SPI mode there is not the feature to program FPER in
McBSP. I want to read 16-bit samples every 125us in SPI mode. (it is
compulsory). I want to use DMA and...
Hi everyone, I'm relatively new to using the PEP5416. I'm using code
composer v3.1, and am having trouble performing a simple audio
read/write task. I'm working with the exampl...
Dear all,
Do you know any C code for working mcbsp in spi mode and using DMA?
I changed the example of TI which use mcbsp by dma but when I changed mcbsp to spi mode that example...
Somebody please do let me know how can I interface SLIC (Si3210) with
C54X. Application notes from the TI tells that SLIC can be interfaced
with the McBSP. Please somebody tell m...
Dear All,
I want to use McBSP of C54CST in SPI mode, so the following are my questions about that:
1- Does CSL support McBSP in SPI mode? How the SS pin is active?
2- Does McBSP...
Hi
Is it possible in C54x DMA to have two channels in auto-initialization mode but with different Autoinitialize source and destination addresses, simultaneously? Would you descri...
hi everyone.I am new to DSP,now I can load program into the internal daram of c5416.In my C program ,I set PMST to be mp/mc#=0 ovly=1 drom=1.Then,how can I load my program into the...
Hi,
I would like to connect codec PCM4201EVM board to DSK5416 Board. Thus, I connected PINS BCK, FSYNC, SDOUT and GND from PCM4201EVM to PINS DC_BCLKR0, DC_FSR0,DC_BDR0 respecti...
-Jeff
"On C54xx devices, SPCR1[0] access requires a sub-address setting; i.e. SPCR1
register, port 0 (McBSP0). Therefore you have to set SPSA0 first (located at address
0x003...