Sign in
Search c54x
Subscribe to c54x
c54x by Keywords
5409 | 5416 | AD5 | ADC | BIOS | Boot | Booting | Bootloader | C540 | C5402 | C5409 | C5416 | CCS | Codec | DMA | Dmad | DSK | DSKPlus | Dsplib | EVM | FFT | FIR | Flash | GPIO | HPI | Initialization | Interrupt | JTAG | LOG_printf | MCBSP | RFFT | RTDX | Sampling | STLM | UART | VC540
Ads
Discussion Groups
Discussion Groups | TMS320C54x | problem with flash programming
Technical discussions about the TI C54x DSPs (including the c5401, c5402, c5402a, c5404, c5407, c5409, c5409a, c5410, c5410a, c5416, c5420, c5421, c5441, c549, c5470 and c5471).
Re: problem with flash programming - Joel Ironstone - Sep 4 4:20:00 2002
|
>I have had this problem before and it is a bug on the DSK. There are two >ways around it, The first is to ground all of the parallel port data pins coming off the dsk. The other is to Switch off (up) Switch #1 on SW1, This disconnects the parallel port from the DSK. I suggest the second. Joel >________________________________________________________________________ >________________________________________________________________________ > >Message: 2 > Date: Wed, 04 Sep 2002 07:23:31 -0000 > From: "satish_tvs" <> >Subject: problem with flash programming > >hello, > >i have one application. i have created .hex file and programmed flash >using flash burn utility. when i have removed jp2 and reset the dsk, >application is running fine. but if i remove my parallel port >connection and reset the dsk once again, the application in the flash >is not running. When dsk board is connected to parallel port flash >booting is fine. but if i remove parallel port then flash bootin is >not taking place. If any body has experienced same problem, please >help me. > >thank u, > >satish |
(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )
problem with flash programming - satish_tvs - Sep 4 7:23:00 2002
|
hello, i have one application. i have created .hex file and programmed flash using flash burn utility. when i have removed jp2 and reset the dsk, application is running fine. but if i remove my parallel port connection and reset the dsk once again, the application in the flash is not running. When dsk board is connected to parallel port flash booting is fine. but if i remove parallel port then flash bootin is not taking place. If any body has experienced same problem, please help me. thank u, satish |
|
|
(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )