5409 | 5416 | AD5 | ADC | BIOS | Boot | Booting | Bootloader | C540 | C5402 | C5409 | C5416 | CCS | Codec | DMA | Dmad | DSK | DSKPlus | Dsplib | EVM | FFT | FIR | Flash | GPIO | HPI | Initialization | Interrupt | JTAG | LOG_printf | MCBSP | RFFT | RTDX | Sampling | STLM | UART | VC540

Hi,
I got same the  error. But i am running in simulator.
Is it because of .cmd file? 

Expecting solution for this.
Regards,
gnanavelu

>  
>
>    
>    
>hi,  
>  
>1) check that connection between dsp and jtag is  
>proper.  
>2) check that jtag is getting power  
>3) run the emulator diagnostics to see that emulator  
>detects the device correctly.  
>4) try switch off and switch on of the entire setup  
>  
>regards,  
>Dileepan.  
>--- jaga_lemonde <> wrote:  
>  
>>   
>>   
>>   
>> Hi,  
>> I am working in g.729 using TMS320C5402 target.  
>> In the encoder section,Once I run the program i face  
>> the following error.  
>>   
>> The Error is  
>> Trouble Running Target CPU: Error Number -2600 Error  
>> address -3  
>>   
>> give your suggestion to overcome this error.  
>>   
>>

(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )

Hi,
        The problem is due to stack is over written by other values. The main reason for this
error is Stack is corrupted. 

To rectify the problem make sure that you have enabled memory mapping option which is present
under options in the menu bar.

Regards
 Sridhar. A
 Hellosoft India Pvt. Ltd
 Hyderabad.

p...@yahoo.com wrote:                                  Hi,
 I got same the  error. But i am running in simulator.
 Is it because of .cmd file? 
 
 Expecting solution for this.
 
 Regards,
 gnanavelu
 
 >  
 >
 >    
 >    
 >hi,  
 >  
 >1) check that connection between dsp and jtag is  
 >proper.  
 >2) check that jtag is getting power  
 >3) run the emulator diagnostics to see that emulator  
 >detects the device correctly.  
 >4) try switch off and switch on of the entire setup  
 >  
 >regards,  
 >Dileepan.  
 >--- jaga_lemonde <> wrote:  
 >  
 >>   
 >>   
 >>   
 >> Hi,  
 >> I am working in g.729 using TMS320C5402 target.  
 >> In the encoder section,Once I run the program i face  
 >> the following error.  
 >>   
 >> The Error is  
 >> Trouble Running Target CPU: Error Number -2600 Error  
 >> address -3  
 >>   
 >> give your suggestion to overcome this error.  
 >>   
 >>

---------------------------------
 Check out what you're missing if you're not on Yahoo! Messenger 

(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )