Simulate with CCS | TMS320C54x

Technical discussions about the TI C54x DSPs (including the c5401, c5402, c5402a, c5404, c5407, c5409, c5409a, c5410, c5410a, c5416, c5420, c5421, c5441, c549, c5470 and c5471).

Post a new Thread

Hi there, can anyone tell me if it is possible to simulate a program in CCS without being connected to the DSK board. I'm using CCS 1.21. Is there a way to switch CCS into simulation mode? I have some programs that I want to test first before I load them on the CPU. Any suggestions. Thanks Christian

(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )

Hi In the C5000 Code Composer version 1.20 (and the newest version 2.0) which I have used, you have to run the Code Composer Setup program and select/install one of the simulators (in my case C55xx or C54xx simulator). This allows you to simulate and not emulate using hardware connected to your PC. Best regards Torgeir Jakobsen Senior Engineer, Technology Department Aanderaa Instruments AS e-mail: web: www.aanderaa.com phone; +47 55 10 99 00 direct: +47 55 10 99 77 fax: +47 55 10 99 10 ----- Original Message ----- From: <> To: <> Sent: Wednesday, October 24, 2001 4:01 PM Subject: [c54x] Simulate with CCS > Hi there, > > can anyone tell me if it is possible to simulate a program in CCS > without being connected to the DSK board. > I'm using CCS 1.21. > > Is there a way to switch CCS into simulation mode? > I have some programs that I want to test first before I load them on > the CPU. > > Any suggestions. > > Thanks Christian > _____________________________________

(You need to be a member of c54x -- send a blank email to c54x-subscribe@yahoogroups.com )

Sign in

Search c54x

Subscribe to c54x

c54x by Keywords

Ads

Discussion Groups

Discussion Groups | TMS320C54x | Simulate with CCS

Simulate with CCS - Author Unknown - Oct 24 14:01:00 2001

Re: Simulate with CCS - Torgeir Jakobsen - Oct 24 16:55:00 2001