Technical discussions about the TI C55x DSPs (including the c5501, c5502, c5503, c5507, c5509, c5510 and OMAP5910).
Post a new Thread
aimoparru - Oct 24 2006
I was normally connected to my 5509A processor board, suddedly
connection got broken and never got up again. I read that EMU0 and
EMU1 lines should 1, but EMU1 line i...
Jeff Brower - Oct 20 2006
> Actually when i run this code a shrill sound is heard from headphones and
> then every thing stops. And then sometimes nothing comes out (nothing happens).
umer...@yahoo.com - Oct 20 2006
Actually when i run this code a shrill sound is heard from headphones and then every thing stops. And then sometimes nothing comes out (nothing happens). When i use software...
Jeff Brower - Oct 19 2006
> Sorry I was out of town so didn't respond you timely
> No it is not working....even after outptr=1.....now what to do. Ok just
> ell me is there any other way..or h...
umer...@yahoo.com - Oct 19 2006
Sorry I was out of town so didn't respond you timely
No it is not working....even after outptr=1.....now what to do. Ok just ell me is there any other way..or how can we im...
hing...@arlut.utexas.edu - Oct 19 2006
Hello. I am currently running a program which services an interrupt on the INT2 pin of my c5510 dsp. However, every time I run my program on the board, the NMI bit is set to 1, dis...
srav...@rediffmail.com - Oct 19 2006
i'm working on AMRNB project. when i test it on Functional simulator , it is working fine. but when i test the same, on cycle accurate simulator
it is failing!!!! A...
rj...@centrex.no - Oct 16 2006
I need to implement the Goertzel algorithm on a C5509A. Input data is in 24 bit representation. Does anybody have some code I could use?
Jeff Brower - Oct 13 2006
It was pointed out to me that outptr should be initialized to 1 to get the
full 4 sec delay:
inptr = 0;
outptr = 1;
Let me know if it works, or at least gets y...
Jeff Brower - Oct 12 2006
> I couldn't get your second hint related to single circular ....I/O pointer shifted
> tio each others.So far as your point of not debugging my assignment is concerned,