I get the following warnings when I try to build my project:

warning: relocation overflowed; the 17-bit relocated address 0x11e66 is too
   large to encode in the 16-bit field (type = 'RE_XSTFLD' (16406), file =
   "C:\\dev\\gen5\\ML\\MLtest_16\\Debug\\Configuration1cfg.obj", offset =
   0x00000000, section = ".gblinit")
warning: relocation overflowed; the 17-bit relocated address 0x11866 is too
   large to encode in the 16-bit field (type = 'RE_XSTFLD' (16406), file =
   "C:\\dev\\gen5\\ML\\MLtest_16\\Debug\\Configuration1cfg.obj", offset =
   0x00000008, section = ".gblinit")
What are these and how do I get rid of them since my code will not run now?
I didn't have these the last time I tried to build my project which was about a month ago. The
only thing different is I loaded a new DSP Bios.

thanks
Monika
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

______________________________
New Year Gift for Members of DSPRelated.com.  Details here.

Hi Monika,

I ran into the same problem, with a project which used to build just 
fine for a long time. The only way I can build it now is by reverting, I 
went back to CG Tools 3.3.2 and DSP/BIOS 5.31.02.
I have had many exchanges with a Mr. Natarajan at Ti Support, but so far 
to no avail. If you find out what is wrong I'd be most grateful for any 
tips.

Best,

Paul Pignon

m...@hotmail.com wrote:
>
> I get the following warnings when I try to build my project:
>
> warning: relocation overflowed; the 17-bit relocated address 0x11e66 
> is too
> large to encode in the 16-bit field (type = 'RE_XSTFLD' (16406), file =
> "C:\\dev\\gen5\ \ML\\MLtest_ 16\\Debug\ \Configuration1c fg.obj", offset =
> 0x00000000, section = ".gblinit")
> warning: relocation overflowed; the 17-bit relocated address 0x11866 
> is too
> large to encode in the 16-bit field (type = 'RE_XSTFLD' (16406), file =
> "C:\\dev\\gen5\ \ML\\MLtest_ 16\\Debug\ \Configuration1c fg.obj", offset =
> 0x00000008, section = ".gblinit")
>
> What are these and how do I get rid of them since my code will not run 
> now?
> I didn't have these the last time I tried to build my project which 
> was about a month ago. The only thing different is I loaded a new DSP 
> Bios.
>
> thanks
> Monika
>
>  
-- 
Paul Pignon, CTO
p...@bps.co.ee
Tel. +372 7302641
Mob. +372 53463942
Skype: paulspignon

Borthwick-Pignon OÜ
Riia 181
Tartu Science Park
51014 Tartu
Estonia
EU
http://bps.co.ee

______________________________
New Year Gift for Members of DSPRelated.com.  Details here.