Hi,

Recently I made the McBSP2 for OMAP5912 working from the ARM side. I
understood from the TRM that ARMPER_CK provides the interface clock and the
functional clock required for McBSP2.

But now I have problems in getting the OMAP5912 McBSP1 working from the ARM
side. Here I am using the same program that I used for McBSP2, but with a
different base address(0xE1011800) which needs to be used for McBSP1.
Basically from the TRM, I understood that the DSP is supplying clocks for
McBSP1. So I may require to configure the DSP side clocks. Can anyone help
me with the sequence of steps / code required to set the clocks at the DSP
side to make the McBSP1 working.

Regards,

Pramod

------------------------------------

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467