Hi all,

I am working on TMS320VC5509A processor which is on a custom board.

While using Flash Burn utility for this board to program/erase flash, the utility is not
showing the connectivity between Emulator and Flash.

Actually few days back the tool was showing connectivity between flash and emulator.

Is it a software problem? 
While installation is there any specific sequence to install the software (like CCS, Emulator
driver, 5509a Board driver, Flash burn utility etc) ?

Regards,
Onkar Patki 

------------------------------------

OMAP35x EVM jump-starts low-power apps
------------------------------------
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to start building
applications based on the OMAP35x architecture:http://www.DSPRelated.com/omap35x