AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Dear friends;
Would any one send me a source code for gpio on ds6713?
When I try to config gpio by gpio-config(); an error message display that there is an
unrecognized token and the other error message says that an expression expected while I do all
my can.
regards
>  Hi,  
>  
>I am implementing a design using the MsASP configured as GPIO and the   
>GPIO module itself. I saw that it is possible to access the McASP   
>pinouts through the HPI Expansion Connector on the dsk but I dont know   
>how to access the GPIO pinout. I am using GPIO_5 and GPIO_6 as external   
>interrupts and the rest the the module as IO's. Is there a daughter-  
>card that has to be used to access these pins?  
>  
>Thanks in advance,  
>  
>Frank  
>  
>  
>  
>  
>  
>  
>     
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )