AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Hi,

Has anybody here had success with using SPI boot on the C672x
processors? I cant find any information from TI other than "it uses
motorola SPI mode", and elsewhere 16 bit address / 8 bit data.

I cant find any information on the configuration details used by the
bootloader ROM code to read a SPI slave device. Polarity? Expected
read byte sequences? Command codes used? Hold function? Does it go
through a range of alternatives until it can read the magic number?

Anyone got any clues? I just spent a few hours looking and found
nothing in TI documentation. I'm trying to design some hardware and
would rather avoid using parallel flash.

cheers,

Chris

------------------------------------

OMAP35x EVM jump-starts low-power apps
------------------------------------
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to start building
applications based on the OMAP35x architecture:http://www.DSPRelated.com/omap35x

(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )