AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Mike and Vladimir, thank you, I have solved the problems with my McBSP
reading your messages!

Toni

Hi everybody!
>
>I'm new in the DSP world and my entire life depends of this!! i have a very
big trouble and i don't know how to fixed out...  The questions is as follows:
>
>I have one dsk6711 and one dsk6713.  I need to transfer data between them
(an array with 128 elements) using McBSP. I'm using the following example code
to do that (please see spra455a  "Using the TMS320C6000 McBSP as a High
Speed Communication Port (Rev. A)" ). 
>
>C6711 is master and C6713 is slave. I'm using CCStudio_v3.1 and i have a few
questions:
>
>1- I need to make two different projects? (one for C6711 and another for
C6713?) how can i run both at the same time using Parallel Debug Manager?
>
>2- The registers in McBSP_config and EDMA_config are ok??
>
>3- What else i need? 
>
>Please post code too. Thanks!

_____________________________________

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )