AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Have you tried to search for the board support package on the matlab web site? You might also take a look at the SMT6040 and SMT6050 toolboxes for Simulink at http://www.sundance.com If matlab genrates a plane C code (as I once saw an example of a simple algorithm, it really does so, but the code was very much unreadable and it took a lot of craft work to make it works), anyway, once you have a C code you can make a project in the CCS and embed the code into the project. Hope this helps, Andrew > Date: Mon, 5 Apr 2004 01:11:31 -0700 (PDT) > From: pranav kumar <> > Subject: sending the matlab code to DSK6711 > > hi, > > I have a small problem in sending matlab code over to DSK 6711. > > WE hae coded the LPC-12 in matlab for speech compression and it is > working fine over the matlab. Now we intended to run the code over > DSK6711 and we are unable to send the code to the processor in matlab. > > Can anyone kindly explain me the procedure to run the matlab code over > the 6711, so that i can correct my mistakes. > pranav

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )