AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Hello, I have problem with the ADC THS1206 in Single Conversion Mode. The converted values are not constant - they have a range of about 28 to 52 digits (depending on the channel). In Continuous Conversion Mode all works fine with a range of 5 digits over 1 million values each channel (short connection between AINP, AINM, BINM, BINP REFIN and REFOUT). I use the THS1206EVM-daughterboard on an C6711DSK-board, 4 channels in single ended mode and use timer0 in clock_mode to generate the /CONVST-signal of about 500kHz. The timing seams to be ok (SLAS217F.pdf page 10). I read the values automaticaly by EDMA (fifo- level 4). What can be the problem? Have someone experiences or a good idea? Thanks Diethelm

(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )