AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Hi, I am newer to c6000 and I'm trying to use the TMS320C6000 McBSP to interface to an IOM-2 compliant device .I am working on a 6711DSK using CCS version 2.10. I followed the application report document (SPRA569A) for TI. After build the program, I have several errors, especially: undefined first referenced symbol in file --------- ---------------- _vectors C:\ti\myprojects\IOM-2\Debug\iom2.obj >> error: symbol referencing errors - iom2.out not built To build the program, it seems necessary to give a value different of 0x000000 to the symbol _vectors. Not having a value recommended in TI documentations, I have arbitrarily chosen the value of 0x000001. this allowed to build correctly the program. However, when I tried running the program, I obtain the list of following errors: "Can't Set Breakpoint: Cannot set/verify breakpoint at 0xDAE8 Breakpoint Manager: An error was encountered attempting to set a breakpoint used for end of program detection. Trouble Halting Target CPU : Timeout on Target Processor Please check cabling or multi-processor configuration It is recommended to RESET EMULATOR. This will disconnect each target, perform an emulation reset, and then reconnect each target. The target should then be power cycled or hard reset. Trouble Reading Target CPU memory: Processor accessing not ready memory at 0xF8B4" Any idea what could be the cause? Thank you in advance for your help,

(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )