ARM7 | BIOS | Bug | EVM | JTAG | Linker | LOG_printf | McBSP | Profiling | Relocation | RTDX | Simulator | Target | Watch

Dear Friends
When I want to install the "xds510pp plus" emulator for CCS 3.1 after doing all
required procedures the following message appears after setting up and running CCS3.1:

Can't Initialize Target CPU:
Error 0x80002240/-118
Fatal Error during: Initialization, OCS, Control, 
This error was generated by TI's USCIF driver.

SC_ERR_CTL_PORT <-118>
An invalid controller port value has been used.
Thus Unified-SCIF will not attempt to detect a controller
The standard 560 ports are 0x0, 0x1, 0x2 and 0x3.
The standard EVM ports are 0x0, 0x1, 0x2 and 0x3.
The standard DSK ports are 0x378, 0x278 and 0x3BC.
The standard 510 ports are 0x240, 0x280, 0x320 and 0x340.
I/O Port = 378

Board Name: C54CST XDS510 Emulator
Cpu Name: CPU_1

Abort:		Close Code Composer Studio.
Retry:		Try to initialize the target again.
Ignore:		Ignore the initialization error and start
		without target debugging access.
Diagnostic:	Run diagnostic utility.

But when I install the Emulator for CCS2.2 It works properly. Do you know what is the reason?
Regards
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

(You need to be a member of code-comp -- send a blank email to code-comp-subscribe@yahoogroups.com )