ARM7 | BIOS | Bug | EVM | JTAG | Linker | LOG_printf | McBSP | Profiling | Relocation | RTDX | Simulator | Target | Watch

Hi,

Am using CCS v3.1 platinum edition, to work on OMAP 1510 innovator kit. The  Sdopts.cfg
displays the following on emu-check:

** Emulator Test **

 $$ EmuProductName=XDS510PP_PLUS

 $$ EmuPortAddr=0x378

 $$ EmuPortMode=SPP8

 $$ ProductId=10

 $$ ProductVersion=02

 ** Emulator Scan Test

   -- Found JTAG IR length of 50

   -- Found 3 JTAG device(s) in the scan chain

 **Emulator is reset

The emulator is XDS510PP-Plus. my printer port is configured to 0x378.

i try setting the CCS setting as follows:

Filters: 
Family: OMAP

There are two omap1510 boards... one with xds510 and the other with xds560 emulator. so i
choose the first one: "OMAP1510 ES2 XDS510 Emulator".

But its port is configured to 0x240. Am not able to change it to 0x378 as the drop-down list
doesnt have the 0x378 option.

when i try to save the settings and start ccs and Debug-->Connect it says:

Error connecting to the target:
Error 0x80000240/-180
Fatal Error during: Initialization, OCS, 
This error was generated by TI's USCIF driver.

SC_ERR_CTL_NO_TRG_POWER <-180>
The controller has detected a target power loss.
The user may have failed to turn-on or connect its source.

need some help on this..

Regards,
Mohammed Shareef
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution
for Commercial & Consumer End Equipment: www.ti.com/dm6467

(You need to be a member of code-comp -- send a blank email to code-comp-subscribe@yahoogroups.com )