Technical discussions about Freescale (Motorola) DSPs (including the DSP56000, DSP56300, DSP56600, 56800 DSPs).
Post a new Thread
haoyeshen - Aug 15 2006
Under 56F8013AVFE bean, there are two places to specify the clock
One is Oscillator Frequency default at 8MHz and another is System Clock
which can be set to 32MH...
wang391 - Jul 30 2006
I am new to DSP world and know nothing about the embedded software
development so far.
I am targeting for DSP56L307 chip. I am wondering if anyone who has
maku...@euromail.hu - Jul 5 2006
i'm a beginner trying to program the motorola 56f8300demo board using codewarrior 7.0 for freescale 56800/e hybrid controllers.
i'm trying to experiment with the demo examp...
Ravi...@geind.ge.com - Jun 27 2006
I want to address each pin of GPIO port serperately (PortA in 56F8323) in C porgramming. Can some one provide me the header file or sample program for the same.
Thanks in ...
Ravi...@geind.ge.com - Jun 22 2006
We are using MC56F8323EVM. We are trying to do serial communication for last three days without any success.
We tried with both SCI0 and SCI1. We are able to receive da...
Hardeep - Jun 19 2006
I have a couple of questions related to interfacing the SPI module
(DSP56858) to a temperature sensor (TMP122:
http://focus.ti.com/lit/ds/symlink/tmp122.pdf ). The TMP1...
drexlmeier - Jun 17 2006
im using the FlexCan Module from 56f8345 Processor and it works under=20
normal conditions fine, but somtimes some ID_low register changes its=20
Stephane Lesoinne - Jun 15 2006
I've been looking in the data sheets for the Immediate Long Addressing
Mode (#> ) but I'm not sure I've understood it clearly.
move #> 192,x1
Gentcho Nikolov - Jun 15 2006
I want to use unused part of FLASH as area to store
some parameters. Using corresponding bean it works,
but only when "waiting in RAM" is enabled. Code
Sik - Jun 5 2006
---------- Forwarded message ----------
Date: 03/06/2006 10:34
Subject: Re: [motoroladsp] urgent question about Motorola 56F8323,
signals, DSPcore, time