56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi all, Does anybody know of a way to use TOD with external oscillator frequency higher than 6MHz (actually it's 80MHz)with the DSP56F827? Thank you in advance Ari Tidhar

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )

TOD input comes from crystal oscillator rather than PLL. So even PLL stop working, TOD still can count input pulse from crystal oscillator. If you use external oscillator, you should run above 6Mhz. But you must carefully connect your clock on correct pin. Please see the following comment from Motorola. "If external clock frequency is greater than 4Mhz and Time of Day module is in use, Connect clock source to XTAL and EXTAL must be connected to VDDA/2. Customer can use resistor divider to get VDDA/2." Charlie Wu --- "atid2 <>" <> wrote: > Hi all, > > Does anybody know of a way to use TOD with external > oscillator > frequency higher than 6MHz (actually it's 80MHz)with > the DSP56F827? > > Thank you in advance > Ari Tidhar __________________________________________________

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )