56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Moin, So CW6 and my DEMO Board were up and running, but after having tried to install the hacks for using ads56800 I am back where I was last week, nothing works anymore, neither ads56800 nor the CW6 download. Could it perhaps be the problem that I once had the Suite56 Parallel Command Converter (a.k.a. "Wiggler") installed for DSP563XX ? Should I solder the JTAG connector and use this wiggler, or is this one functionally identical with the circuit on the DEMO board? What can I do about "CCS: Driver failure"? Anyone successfully using ads56800? Thanks, Stefan

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )