56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hello I have a small question according to ISR. I'm using the SDK to set up most of my Interrupts. Now I had to program 1 Interupt in assembly with the Priority 5. (This ISR uses about 50% of my DSP ressource.) The Interrupt handling and the timing according to the priority works fine.The ASM ISR stops the lower ISR from running if required. It is a motion application and for safety reason I had to set up Interrupts with higher priority (6). Now the problem is that this ISR (6) does not stops the Priority 5 ASM routine from running. I checked out the SDK function dispatcher.asm, but coudn't figure out how to set up the SR Register. Thanks for helping and feedbacks Chris Brauchli Brauchli Netsolution Berg Switzerland

______________________________
New Code Sharing Section now Live on DSPRelated.com. Learn about the Reward Program for Contributors here.



(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )