56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi everyone. Let me explaing what I'm trying to do. I developing an application on Visual Basic that will send an "start" signal to my DSP board, the board will execute some code and return the results to VB. I want to do it through the serial port. But I want to do it using interrupts, I mean, that when you send the start signal from VB, the board execute an interruption and run the code. When the results are ready, generate a new interrupt and send the results back to the VB application. I've read the DSP56824EVM Hardware Reference Manual, and found that the MAX3100 handle interrupts through IRQ while the DSP56824 use the IRQA. How can I do this???....I'm using SDK libraries. Thanx José Antonio S.

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )