56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi, I am a newbie to DSP and I have recently acquired a 56362EVM. It has an LCD built into it which I need to use to display settings for a filter sweep effect I am trying to create. I think the LCD is memory mapped to port C but I have no idea how to initialize the LCD for writing or the exact address to send data to. If anyone could give me some pointers or some example assembler code I would greatly appreciate it. Thanks very much. John

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )

John, The LCD is controlled by the 68HC11 microcontroller on the EVM. There's no way to control it directly via the DSP. -- dB --- arnold_the_cat2002 <> wrote: > > Hi, I am a newbie to DSP and I have recently acquired a 56362EVM. It > has an LCD built into it which I need to use to display settings for > a filter sweep effect I am trying to create. I think the LCD is > memory mapped to port C but I have no idea how to initialize the LCD > for writing or the exact address to send data to. If anyone could > give me some pointers or some example assembler code I would greatly > appreciate it. Thanks very much. > > John __________________________________

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )