56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi,everyone:
I use 05EVM and Metrowerks SDK2.4, also i use the embedded RTOS
uc-osII2.51 to develop .
Now i have four tasks and three interrupts. They are two quadTimer
tasks----timerB_0 and TimerB_1, which TimerB_0 have two interrupts---
callbackOnCompare and callbanckOnInputedge .The third interrupt is
Pwm_A_reloadcallback.
Now i can't enter the callbanckOnInputedge, however the other two
interrupts are OK. I am sure that the Timer's registers are set right.
Are their priority the problems?? The priority of pwm's callback is 3
by add "#define GPR_INT_PRIORITY_59 3" in the appconfig.h. And
TimerB_0's callback is set to 2.
I really don't why i can not enter the callbackOnIputedge.I have used
the breakpoint in the ISR. When the process run firstly, it can stop at
the breakpoint, but after it, i restart the process .The process never
stop at the breakpoint.
If someone want see my process to help me resolve this problem, i can
send it to you.
Thank you very much! I need your replys.




(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )