56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi, guys

=20

I=92m working with DPS56F8323 Demo Board but the pin out voltage is less th=
at
3.3v. For instance when I use the TIMER/PWM port as Out toward LCD the Data
pines, RS,RW and ENABLE pins; its voltage is 3.3 on each one. But into
Manual Guide there is something that unknown called CUT_AWAY. Some one know
how work this?

=20

Thanks in advance

=20

Mauricio Zambrano

EQUANT - Colombia

Platforms Support

Calle 94A No. 13-08 Offic 307

Bogot=E0 Colombia

Mobile:  +57 311 810 74 96

Phone:   +57 1 616 63 70 Ext. 104

Fax:     +57 1 655 95 45

=20

=20

=20

=20

=20

=20

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )