56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi,
I'm trying to get the unit of the DEMO56F8014 EVM running in stand alone mode but I have had no
success.

Does anybody knows if the DEMO56F8014 EVM board can run in stand alone mode (without connection
to the debugger in the CodeWarrior IDE) and if there is any document that treats this issue?
Any direction will be appreciated.

Thank you,
Rodrigo

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )

DEMO56F8014 can be run in stand alone mode if flash
security or other break points are not set in your
code.

Charlie,
--- r...@yahoo.com.br wrote:

> Hi,
> I'm trying to get the unit of the DEMO56F8014 EVM
> running in stand alone mode but I have had no
> success.
> 
> Does anybody knows if the DEMO56F8014 EVM board can
> run in stand alone mode (without connection to the
> debugger in the CodeWarrior IDE) and if there is any
> document that treats this issue?
> Any direction will be appreciated.
> 
> Thank you,
> Rodrigo
>

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )