56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

HI everybody,
               Can anybody tell how to creat the Line Fault 
conditions on the CAN bus using the vector tool CANStressDR.

                I think any one who has an experience using this tool 
can help me
                I want to create the Line Faults on the CAN bus using 
the Resistor and Capacitor circuit that is available with the 
CANStressDRtool. I read the Manual of the tool but i still have some 
confusion how to create the test conditions for Line faults on the 
CAN bus using the Analog Disturbance ciruit.

 i want to simulate some following conditions like

   1. Disturbing the CAN_H and CAN_L voltages
   2. Simulating the CAN_H or CAN_L wire breaks etc..

and my CAN bus is a high speed bus with 500Kb/sec
    
  any kind of help can be very uself to me

Thank You
Yadunandan

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )