56303 | 563xx | 5680 | 56805 | 5680x | 56F80 | 56F800DEMO | 56F805 | 56f807 | 56F830 | ADC | Bootloader | Codec | CodeWarrior | CW5 | CW6 | Debugger | DSP56303 | DSP56303EVM | DSP563xx | DSP5680 | DSP56800 | DSP56807 | DSP56858 | DSP56858EVM | DSP56F803 | DSP56F805 | DSP56F807 | DSP56F80x | DSP56F826 | DSP56F827 | DSP56F8xx | EVM | FFT | Flash_over_jtag | GPIO | Interrupt | Interrupts | JTAG | LCD | Linker | MCF5307 | Metrowerks | Modulus | MSCAN | PCMaster | PWM | Quad | Rif | RTOS | SDK | SPI

Hi,
I would like to configure pin 0-1 to PhaseA1/PhaseB1 and pins 2-3 to 
SCI (MISO and MOSI). However the manual is not clear about if this is 
possible (reading about the SIM_GPS). It seems that all four GPIOC pins 
[0:3] have to be configured to the same function (GPIO OR Quad 
decoder/Quad Time B OR SPI1) even though the actual configuration 
through SIM_GPS is done individually.
My conclusion is that I will not be able to use GPIOC pin 2 and 3 sor 
SPI1 signals even though the Quadrature decoder is configured to 
operating mode 2 (ie only using filtered PHASEA and PHASEB signals).

Is my conclusion correct?
If not where is the information that supports this?

(You need to be a member of motoroladsp -- send a blank email to motoroladsp-subscribe@yahoogroups.com )