## Stereophonic Amplitude-Panning: A Derivation of the "Tangent Law"

This article presents a derivation of the "Tangent Law"

## A Brief Introduction To Romberg Integration

This article briefly describes a remarkable integration algorithm, called "Romberg integration." The algorithm is used in the field of numerical analysis but it's not so well-known in the world of DSP.

## An IIR 'DC Removal' Filter

●1 commentIt seems to me that DC removal filters (also called "DC blocking filters") have been of some moderate interest recently on the dsprelated.com Forum web page. With that notion in mind I thought I'd post a little information, from Chapter 13 of my "Understanding DSP" book, regarding infinite impulse response (IIR) DC removal filters.

## Two Easy Ways To Test Multistage CIC Decimation Filters

●1 commentThis article presents two very easy ways to test the performance of multistage cascaded integrator-comb (CIC) decimation filters. Anyone implementing CIC filters should take note of the following proposed CIC filter test methods.

## FFT Interpolation Based on FFT Samples: A Detective Story With a Surprise Ending

●1 commentThis blog presents several interesting things I recently learned regarding the estimation of a spectral value located at a frequency lying between previously computed FFT spectral samples. My curiosity about this FFT interpolation process was triggered by reading a spectrum analysis paper written by three astronomers.

## An Efficient Linear Interpolation Scheme

●3 commentsThis article presents a computationally-efficient linear interpolation trick that requires at most one multiply per output sample.

## Sinusoidal Frequency Estimation Based on Time-Domain Samples

●6 commentsThe topic of estimating a noise-free real or complex sinusoid's frequency, based on fast Fourier transform (FFT) samples, has been presented in recent blogs here on dsprelated.com. For completeness, it's worth knowing that simple frequency estimation algorithms exist that do not require FFTs to be performed . Below I present three frequency estimation algorithms that use time-domain samples, and illustrate a very important principle regarding so called "exact" mathematically-derived DSP algorithms.

## FFT Interpolation Based on FFT Samples: A Detective Story With a Surprise Ending

●1 commentThis blog presents several interesting things I recently learned regarding the estimation of a spectral value located at a frequency lying between previously computed FFT spectral samples. My curiosity about this FFT interpolation process was triggered by reading a spectrum analysis paper written by three astronomers.

## A Brief Introduction To Romberg Integration

This article briefly describes a remarkable integration algorithm, called "Romberg integration." The algorithm is used in the field of numerical analysis but it's not so well-known in the world of DSP.

## An IIR 'DC Removal' Filter

●1 commentIt seems to me that DC removal filters (also called "DC blocking filters") have been of some moderate interest recently on the dsprelated.com Forum web page. With that notion in mind I thought I'd post a little information, from Chapter 13 of my "Understanding DSP" book, regarding infinite impulse response (IIR) DC removal filters.

## An Efficient Linear Interpolation Scheme

●3 commentsThis article presents a computationally-efficient linear interpolation trick that requires at most one multiply per output sample.

## Sinusoidal Frequency Estimation Based on Time-Domain Samples

●6 commentsThe topic of estimating a noise-free real or complex sinusoid's frequency, based on fast Fourier transform (FFT) samples, has been presented in recent blogs here on dsprelated.com. For completeness, it's worth knowing that simple frequency estimation algorithms exist that do not require FFTs to be performed . Below I present three frequency estimation algorithms that use time-domain samples, and illustrate a very important principle regarding so called "exact" mathematically-derived DSP algorithms.

## Two Easy Ways To Test Multistage CIC Decimation Filters

●1 commentThis article presents two very easy ways to test the performance of multistage cascaded integrator-comb (CIC) decimation filters. Anyone implementing CIC filters should take note of the following proposed CIC filter test methods.

## Stereophonic Amplitude-Panning: A Derivation of the "Tangent Law"

This article presents a derivation of the "Tangent Law"