Flash External Devices over JTAG?

Started by Louis Loving in Freescale DSPs16 years ago

Flash External Devices over JTAG? Is it possible to Flash the Atmel Dataflash Device on the DSP56858 EVM over the JTAG...

Flash External Devices over JTAG? Is it possible to Flash the Atmel Dataflash Device on the DSP56858 EVM over the JTAG port without using CodeWarrior?  I see that Motorola


24-bit data on 56852

Started by Polyhex . in Freescale DSPs17 years ago

I have an external 24 bit audio codec I have attached to the ISSI port of the 56852 EVM. The codec only provides a 50/50 fram sync...

I have an external 24 bit audio codec I have attached to the ISSI port of the 56852 EVM. The codec only provides a 50/50 fram sync pulse (high to denote left low to denote right channel). The 56852 only responds to a single pulse frame sync to draw in a 16 bit word. The fram s


Query problem in SCI1 Receive

Started by attel divate in Freescale DSPs15 years ago

Hello,        My  name is attel divate, i am working on the DSP56f805 EVM board for the first time i am working on the SCI0...

Hello,        My  name is attel divate, i am working on the DSP56f805 EVM board for the first time i am working on the SCI0 and SCI1 receive and transmit programs, i am not getting the receive from the PC to the Board, Can anyone please assist me in this regard


SPI problems

Started by Santi Corera in Freescale DSPs17 years ago

I have read some posts with questions about the SPI in 56800 family and I am worried with this matter. I have made some...

I have read some posts with questions about the SPI in 56800 family and I am worried with this matter. I have made some tests with the DSP56F807 EVM and wath I have found


read User Jumpers, 56F8357 eval. board, code snippets

Started by Corey, Rick in Freescale DSPs16 years ago

Hi Here's 2 trivial code snippets for configuring and reading the "User Jumpers" on a 56F8357 evaluation board. These are...

Hi Here's 2 trivial code snippets for configuring and reading the "User Jumpers" on a 56F8357 evaluation board. These are jumpers JG15 and JG16. I configure them as GPIO inputs (open drain). See figure 2-12, section 2.14 of the '357 EVM Hardware User Manual. The alte