56303evm irqa and irqd all dead

Started by rtur...@yahoo.de in Freescale DSPs13 years ago 5 replies

hello all, I have a weird problem. The irqa and irqd switches on my 56303evm have stopped functioning. Everything else is running fine....

hello all, I have a weird problem. The irqa and irqd switches on my 56303evm have stopped functioning. Everything else is running fine. (it's not about my code, they were both functioning fine before with the same program) All of this started when I tried to burn my program into flash perom to no success. I have simulated my programs everthing is running okey, but when the interrupt butto...


Quad timer initialization to generate interrupt on/off time (CMP1/CMP2)

Started by Nitin Madhukar Yewale in Freescale DSPs18 years ago 1 reply

Hi, I am using 56F827 for my project. I want to generate pulse of 160Hz and width i.e. on time is 0.0015 seconds. To generate the...

Hi, I am using 56F827 for my project. I want to generate pulse of 160Hz and width i.e. on time is 0.0015 seconds. To generate the required pulse I have initialized "qt_sState" structure In the following manner. 827 Freq is 80Mhz so peripheral freq is 40Mhz. // 160 Hz


Interrupt Priorities

Started by Elefante Alessandro in Freescale DSPs17 years ago

Hi, Is it  possible to write  the following assembler code that I find in

Hi, Is it  possible to write  the following assembler code that I find in


Dynamic interrupt with CW7.0

Started by Bruno Tremblay in Freescale DSPs15 years ago 2 replies

Hi,               Again with that question. With the SDK, I was using the fu

Hi,               Again with that question. With the SDK, I was using the fu